Ip Route - Dell PowerEdge M420 Reference Manual

ip route

Use the ip route command in Global Configuration mode to configure a
static route. Use the no form of the command to delete the static route. The
IP route command sets a value for the route preference. Among routes to the
same destination, the route with the lowest preference value is the route
entered into the forwarding database. Specifying the preference of a static
route controls whether a static route is more or less preferred than routes from
dynamic routing protocols. The preference also controls whether a static
route is more or less preferred than other static routes to the same
destination.
Syntax
ip addr
ip route {
ip addr
no ip route
ip-address — IP address of destination interface.
•
subnet-mask — Subnet mask of destination interface.
•
prefix-length — Length of prefix. Must be preceded with a forward slash
•
(/). (Range: 0-32 bits)
nextHopRtr — IP address of the next hop router.
•
preference — Specifies the preference value, a.k.a. administrative distance,
•
of an individual static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
For the static routes to be visible, you must:
• Enable ip routing globally.
• Enable ip routing for the interface.
• Confirm that the associated link is also up.
subnetmask prefix length
|
subnetmask
{ |
nextHopRtr
}
prefix length nextHopRtr
}
IP Routing Commands
preference
[ ]
preference
[ ]
921