speed
Use the speed command in port aggregator configuration mode to configure
the speed of all member ports in the aggregator group/zone. To restore the
default, use the no form of this command.
Syntax
[10 | 100 ]
speed
no speed
10 — Configures the port to 10 Mbps operation.
•
100 — Configures the port to 100 Mbps operation.
•
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 1
console(config-aggregator-1)#speed 100
console(config-aggregator-1)#
Port Aggregator Commands
571