Ip Ospf Cost; Ip Ospf Dead-Interval - Dell PowerEdge M420 Reference Manual

ip ospf cost

Use the ip ospf cost command in Interface Configuration mode to configure
the cost on an OSPF interface. Use the no form of the command to return
the cost to the default value.
Syntax
interface-cost
ip ospf cost
no ip ospf cost
inte rface-cost — Specifies the cost (link-state metric) of the OSPF
•
interface. (Range: 1–65535)
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan15)#ip ospf cost 5

ip ospf dead-interval

Use the ip ospf dead-interval command in Interface Configuration to set the
OSPF dead interval for the specified interface. Use the no form of the
command to return the interval to the default value.
Syntax
ip ospf dead-interval
no ip ospf dead-interval
seconds
OSPF Commands
1099