Ipv6 Pim Commands - Dell PowerEdge M420 Reference Manual

IPv6 PIM Commands

This chapter explains the following commands:
ipv6 pim
ipv6 pim sparse (Global
config)
ipv6 pim dense
ipv6 pim bsr-border
ipv6 pim bsr-candidate
ipv6 pim dr-priority
ipv6 pim hello-interval
ipv6 pim
Use the ipv6 pim command to administratively configure PIM mode for IPv6
Multicast routing on a VLAN interface. Use the no form of this command to
disable PIM on the interface.
Syntax
ipv6 pim
no ipv6 pim
Default Configuration
PIM is disabled on interfaces by default.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
There are no user guidelines for this command.
ipv6 pim join-prune-
interval
ipv6 pim register-rate-limit show ipv6 pim interface
ipv6 pim rp-address
ipv6 pim rp-candidate
ipv6 pim spt-threshold
ipv6 pim ssm
show ipv6 pimsm
49
show ipv6 pim bsr-router
show ipv6 pim neighbor
show ipv6 pim rp hash
show ipv6 pim rp mapping
IPv6 PIM Commands
939