Ipv6 Pim Spt-Threshold; Ipv6 Pim Ssm - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

ipv6 pim spt-threshold

Use the ipv6 pim spt-threshold command to set the multicast traffic
threshold rate for the last-hop router to switch to the shortest path on the
router. Use the no form of this command to return the threshold to its default
value (0).
Syntax
ipv6 pim spt-threshold
no ipv6 pim spt-threshold
Parameter Description
Parameter
spt-threshold
Default Configuration
The default threshold rate is 0. This indicates that the multicast router
should always switch to the multicast source tree.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim spt-threshold 1000

ipv6 pim ssm

Use the ipv6 pim ssm command to administratively configure PIM Source
Specific Multicast (SSM) range of addresses for IPv6 multicast routing. Use
the no form of this command to removed configured ranges of addresses from
the router.
948
IPv6 PIM Commands
spt-threshold
Description
The multicast traffic threshold rate in kilobytes per second.
Range: 0–2000 Kbps.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents