Next-Server - Dell PowerEdge M420 Reference Manual

Parameter Description
Parameter
network-number
mask
prefix-length
Default Configuration
This command has no default configuration.
Command Mode
IP DHCP Pool Configuration mode

next-server

Use the next-server command in DHCP Pool Configuration mode to set the
IPv4 address of the TFTP server to be used during auto-install. Use the no
form of the command to remove the next server configuration.
Syntax
ip-address
next-server
no next-server
Parameter Description
Parameter
ip-address
Default Configuration
There is no default IPv4 next server configured.
Command Mode
DHCP Pool Configuration mode
Description
A valid IPv4 address
A valid IPv4 network mask with contiguous left-aligned bits.
An integer indicating the number of leftmost bits in the
network-number to use as a prefix for allocating cells.
Description
The IPv4 address of the TFTP server to use during auto-
configuration.
DHCP Server and Relay Agent Commands
831