Gvrp Enable (Global) - Dell PowerEdge M420 Reference Manual

Default Configuration
The default timer values are as follows:
• Join timer — 20 centiseconds
• Leave timer — 60 centiseconds
• Leaveall timer — 1000 centiseconds
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
relationships
The following
• Leave time must be greater than or equal to three times the join time.
• Leaveall time must be greater than the leave time.
Set the same GARP timer values on all Layer 2-connected devices. If the
GARP timers are set differently on Layer 2-connected devices, the GARP
application will not operate successfully.
timer_value
The
Example
The following example sets the leave timer for port 1/0/8 to 90 centiseconds.
console (config)# interface gigabitethernet 1/0/8
console (config-if-1/0/8)# garp timer leave 90

gvrp enable (global)

Use the gvrp enable (global) command in Global Configuration mode to
enable GVRP globally on the switch. To disable GVRP globally on the switch,
use the no form of this command.
Syntax
gvrp enable
no gvrp enable
for the various timer values must be maintained:
setting must be a multiple of 10.
GVRP Commands
429