Bootpdhcprelay Maxhopcount; Commands In This Chapter - Dell PowerEdge M420 Reference Manual

• The protocol field in the IP header must be UDP (17).
• The destination UDP port must match a configured relay entry.
DHCP relay cannot be enabled and disabled globally. IP helper can be
enabled or disabled globally. Enabling IP helper enables DHCP relay.

Commands in this Chapter

This chapter explains the following commands:

bootpdhcprelay maxhopcount

bootpdhcprelay minwaittime
clear ip helper statistics
ip dhcp relay information check
ip dhcp relay information check-reply
ip dhcp relay information option
ip dhcp relay information option-insert
bootpdhcprelay maxhopcount
Use the bootpdhcprelay maxhopcount command in Global Configuration
mode to configure the maximum allowable relay agent hops for BootP/DHCP
Relay on the system. Use the no form of the command to set the maximum
hop count to the default value.
Syntax
bootpdhcprelay maxhopcount
no bootpdhcprelay maxhopcount
integer — Maximum allowable relay agent hops for BootP/DHCP Relay on
•
the system. (Range: 1-16)
Default Configuration
integer
The default
integer
configuration is 4.
ip helper-address (global configuration)
ip helper-address (interface
configuration)
ip helper enable
show ip helper-address
show ip dhcp relay
show ip helper statistics
IP Helper/DHCP Relay Commands
899