Area Virtual-Link Transmit-Delay - Dell PowerEdge M420 Reference Manual

neighbor — Router ID of neighbor.
•
seconds — Retransmit interval. (Range: 0-3600)
•
Default Configuration
5 is the default value for
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the retransmit interval of 20 seconds for
the OSPF virtual interface on the virtual interface identified by area 1 and its
neighbor.
(config)#ipv6 router ospf
(config-rtr)#area 1 virtual-link 2 retransmit-
interval 20

area virtual-link transmit-delay

Use the area virtual-link transmit-delay command in Router OSPFv3
Configuration mode to configure the transmit delay for the OSPF virtual
interface on the virtual interface identified by
Syntax
areaid
area virtual-link
areaid
no area
areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Transmit delay interval. (Range: 0-3600)
•
1158
OSPFv3 Commands
seconds
neighbor
neighbor
virtual-link
.
areaid
seconds
transmit-delay
transmit-delay
neighbor
and .