Distance Ospf - Dell PowerEdge M420 Reference Manual

Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets a default of 100 for the metric of distributed
routes.
console(config)#ipv6 router ospf
console(config-rtr)#default-metric 100

distance ospf

The distance ospf command sets the preference values of OSPF route types
in the router. Lower route preference values are preferred when determining
the best route. The type of OSPF route can be intra, inter, external. All the
external type routes are given the same preference value. Use the "no" form of
this command to reset the preference values to the default.
Syntax
distance ospf {external | inter-area | intra-area }
no distance ospf {external | inter-area | intra-area }
distance — Used to select the best path when there are two or more routes
•
to the same destination from two different routing protocols (Range:
1–255).
Default Configuration
The default preference value is 110.
Command Mode
Router OSPF Configuration mode.
Router OSPFv3 Configuration mode.
distance
distance
OSPFv3 Commands
1161