Redistribute - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Example
The following example allows no RIP control packets to be sent by VLAN 11.
console(config-if-vlan11)#ip rip send version none

redistribute

The redistribute command configures RIP protocol to redistribute routes
from the specified source protocol/routers. If the source protocol is OSPF,
there are five possible match options.
Syntax
redistribute ospf [metric
[nssa-external 1] [nssa-external 2]]
no redistribute ospf
redistribute { static | connected} [metric
integer — Specifies the metric to use when redistributing the route.
metric
Range: 0-15.
match internal — Adds internal matches to any match types presently
being redistributed.
match external 1 — Adds routes imported into OSPF as Type-1 external
routes into any match types presently being redistributed.
match external 2 — Adds routes imported into OSPF as Type-2 external
routes into any match types presently being redistributed.
match nssa-external 1 — Adds routes imported into OSPF as NSSA Type-
1 external routes into any match types presently being redistributed.
match nssa-external 2 — Adds routes imported into OSPF as NSSA Type-
2 external routes into any match types presently being redistributed.
static — Redistributes static routes.
connected — Redistributes directly-connected routes.
Default Configuration
integer
metric
match — internal
1222
Routing Information Protocol Commands
integer
— not configured
] [match [internal] [external 1] [external 2]
integer
]

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents