Ip Ospf Priority; Ip Ospf Retransmit-Interval - Dell PowerEdge M420 Reference Manual

broadcast
point-to-point Set the OSPF network type to Point-to-Point

ip ospf priority

Use the ip ospf priority command in Interface Configuration mode to set the
OSPF priority for the specified router interface. Use the no form of the
command to return the priority to the default value.
Syntax
number-value
ip ospf priority
no ip ospf priority
number-value
•
interface. (Range: 0–255)
Default Configuration
1 is the default integer value.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
A value of 1 is the highest router priority. A value of 0 indicates that the
interface is not eligible to become the designated router on this network.
Example
The following example sets the OSPF priority for the VLAN 15 router at 100.
console(config-if-vlan15)#ip ospf priority 100

ip ospf retransmit-interval

Use the ip ospf retransmit-interval command in Interface Configuration
mode to set the OSPF retransmit Interval for the specified interface. Use the
no form of the command to return the interval to the default value.
Set the OSPF network type to Broadcast
— Specifies the OSPF priority for the specified router
OSPF Commands
1103