Show Ipv6 Ospf Range - Dell PowerEdge M420 Reference Manual

ID Time
--------- -------- ---- ----------- ------------- ----
console#show ipv6 ospf neighbor interface tunnel 1
IP Address..................................... Err
ifIndex........................................ 619
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 1
(computed)
OSPF Mtu-ignore................................ Disable
OSPF cannot be initialized on this interface.

show ipv6 ospf range

Use the show ipv6 ospf range command in Privileged EXEC mode to display
information about the area ranges for the specified area identifier.
Syntax
areaid
show ipv6 ospf range
areaid — Identifies the OSPF area whose ranges are being displayed.
•
Default Configuration
This command has no default configuration.
1198
OSPFv3 Commands