User Guidelines
This command has no user guidelines.
Example
The following example configures the translator stability interval of the area
20 NSSA.
console(config-router)#area 20 nssa translator-stab-
intv 2000
area range (Router OSPF)
Use the area range command in Router OSPF Configuration mode to
configure a summary prefix for routes learned in a given area. There are two
types of area ranges. An area range can be configured to summarize intra-area
routes. An ABR advertises the range rather than the specific intra-area route
as a type 3 summary LSA. Also, an area range can be configured at the edge of
an NSSA to summarize external routes reachable within the NSSA. The range
is advertised as a type 5 external LSA.
Syntax
area-id
area
range
[advertise | not-advertise]
area-id
no area
nssaexternallink}
Parameter Description
Parameter
area-id
ip-address
subnet-mask
summarylink
nssaexternallink
advertise
1076
OSPF Commands
ip-address subnet-mask
ip-address subnet-mask
range
Description
Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
IP address.
Subnet mask associated with IP address.
Specifies a summary link LSDB type.
Specifies an NSSA external link LSDB type.
Advertisement of the area range.
{summarylink | nssaexternallink}
{summarylink |