Ipv6 Ospf Retransmit-Interval - Dell PowerEdge M420 Reference Manual

User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF priority at 50 for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf priority 50

ipv6 ospf retransmit-interval

Use the ipv6 ospf retransmit-interval command in Interface Configuration
mode to set the OSPF retransmit interval for the specified interface.
Syntax
ipv6 ospf retransmit-interval
no ipv6 ospf retransmit-interval
seconds — The number of seconds between link-state advertisement
•
retransmissions for adjacencies belonging to this router interface. This
value is also used when retransmitting database description and link-state
request packets. (Range: 0 to 3600 seconds)
Default Configuration
5 seconds is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF retransmit interval at 100 seconds.
console(config)#interface vlan 15
seconds
OSPFv3 Commands
1171