Ip Igmp Snooping Mcrtrexpiretime - Dell PowerEdge M420 Reference Manual

Command Mode
VLAN Configuration mode
User Guidelines
When using IGMP Snooping Querier, this parameter should be less than the
value for the IGMP Snooping Querier query interval.
Example
The following example sets the maximum response time to 60 seconds on
VLAN 2.
console(config-vlan)#ip igmp snooping maxresponse 2
60

ip igmp snooping mcrtrexpiretime

This command sets the Multicast Router Present Expiration time. The time
is set on a particular VLAN. This is the amount of time in seconds that a
switch waits for a query to be received on an interface before the interface is
removed from the list of interfaces with multicast routers attached. The range
is 1–2147483647 seconds. A value of 0 indicates an infinite time-out (no
expiration). The no form of this command sets the Multicast Router Present
Expiration time to 0. The time is set for a particular VLAN.
Syntax
ip igmp snooping mcrtexpiretime
no ip igmp mcrtexpiretime
vlan id — Number assigned to the VLAN
•
seconds — Multicast router present expiration time. (Range: 1–3600)
•
Default Configuration
The default multicast router present expiration time is 300 seconds.
Command Mode
VLAN Configuration mode
vlan-id seconds
vlan-id
IGMP Snooping Commands
449