Ip Rip Receive Version - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the RIP Version 2 Authentication Type and Key
for VLAN 11.
console(config-if-vlan11)#ip rip authentication
encrypt pass123 35

ip rip receive version

Use the ip rip receive version command in Interface Configuration mode to
configure the interface to allow RIP control packets of the specified version(s)
to be received. Use the no form of the command to return the version to the
default value.
Syntax
ip rip receive version {rip1 | rip2 | both | none}
no ip rip receive version
rip1 — Receive only RIP version 1 formatted packets.
rip2 — Receive only RIP version 2 formatted packets.
both — Receive packets from either format.
none — Do not allow any RIP control packets to be received.
Default Configuration
Both is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
1220
Routing Information Protocol Commands

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents