Router-Id - Dell PowerEdge M420 Reference Manual

Parameter
metric-value
type-value
tag-value
subnets
Default Configuration
0 is the tag-value default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures OSPF protocol to allow redistribution of
routes from the specified source protocol/routers.
console(config-router)#redistribute rip metric 90
metric-type 1 tag 555 subnets

router-id

Use the router-id command in Router OSPF Configuration mode to set a 4-
digit dotted-decimal number uniquely identifying the router OSPF ID.
Syntax
ip-address
router-id
ip-address — IP address that uniquely identifies the router OSPF ID.
•
Description
Specifies the metric to use when redistributing the route.
(Range: 0–16777214)
Type 1 external route.
Type 2 external route.
Value attached to each external route, which might be used to
communicate information between ASBRs. (Range:
0–4294967295)
Specifies whether to redistribute the routes to subnets.
OSPF Commands
1113