Show Interfaces Switchport - Dell PowerEdge M420 Reference Manual

EtherType

show interfaces switchport

Use the show interfaces switchport command in Privileged EXEC mode to
display switchport configuration.
Syntax
show interfaces switchport {{gigabitethernet
port-channel-number | tengigabitethernet unit/slot/port }}
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following example displays switchport configuration individually for
gi1/0/1.
console#show interface switchport gigabitethernet
1/0/1
Port 1/0/1:
VLAN Membership mode: General
Operating parameters:
730
VLAN Commands
This field represents a 2-byte hex EtherType to be used as the first
16 bits of the DVLAN tunnel. The three different EtherType tags
are: (1) 802.1Q, which represents the commonly used value of
0x8100. (2) vMAN, which represents the commonly used value of
0x88A8. (3) If EtherType is not one of these two values, it is a
custom tunnel value, representing any value in the range of 0 to
65535.
unit/slot/port
| port-channel