Arp Dynamicrenew - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Default Configuration
The default integer value is 896.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example defines an arp cachesize of 500.
console(config)#arp cachesize 500

arp dynamicrenew

Use the arp dynamicrenew command in Global Configuration mode to
enable the ARP component to automatically renew dynamic ARP entries
when they age out. To disable the automatic renewal of dynamic ARP entries
when they age out, use the no form of the command.
Syntax
arp dynamicrenew
no arp dynamicrenew
Default Configuration
The default state is disabled.
Command Mode
Global Configuration mode
User Guidelines
When an ARP entry reaches its maximum age, the system must decide
whether to retain or delete the entry. If the entry has recently been used to
forward data packets, the system will renew the entry by sending an ARP
request to the neighbor. If the neighbor responds, the age of the ARP cache
802
ARP Commands

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents