Switchport General Ingress-Filtering Disable - Dell PowerEdge M420 Reference Manual

switchport general allowed vlan remove
vlan-list — List of VLAN IDs to add. Separate nonconsecutive VLAN
add
•
IDs with a comma and no spaces. Use a hyphen to designate a range of
IDs.
vlan-list — List of VLAN IDs to remove. Separate nonconsecutive
remove
•
VLAN IDs with a comma and no spaces. Use a hyphen to designate a range
of IDs.
• tagged — Sets the port to transmit tagged packets for the VLANs. If the
port is added to a VLAN without specifying tagged or untagged, the
default is untagged.
• untagged — Sets the port to transmit untagged packets for the VLANs.
Default Configuration
Untagged.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
You can use this command to change the egress rule (for example, from
tagged to untagged) without first removing the VLAN from the list.
Example
The following example shows how to add VLANs 1, 2, 5, and 8 to the allowed
list.
console(config-if-1/0/8)#switchport general allowed
vlan add 1,2,5,8 tagged

switchport general ingress-filtering disable

Use the switchport general ingress-filtering disable command in Interface
Configuration mode to disable port ingress filtering. To enable ingress
filtering on a port, use the no form of this command.
vlan-list
VLAN Commands
741