Ipv6 Pimsm Bsr-Candidate - Dell PowerEdge M420 Reference Manual

Syntax
ipv6 pimsm bsr-border
no ipv6 pimsm bsr-border
Default Configuration
BSR-border is disabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pimsm bsr-border

ipv6 pimsm bsr-candidate

Use the ipv6 pimsm bsr-candidate command to configure the router to
announce its candidacy as a bootstrap router (BSR). Use the "no" form of this
command to stop the router from announcing its candidacy as a bootstrap
router.
Syntax
ipv6 pimsm bsr-candidate vlan
no ipv6 pimsm bsr-candidate vlan
vlan-id — A valid VLAN ID value.
•
hash-mask-len —The length of a mask that is to be ANDed with the group
•
address before the hash function is called. All groups with the same seed
hash correspond to the same RP. For example, if this value is 24, only the
first 24 bits of the group addresses matter. This allows you to get one RP
for multiple groups. (Range 0–128 bits).
vlan-id hash-mask-len
vlan-id
IPv6 Multicast Commands
priority
[ ]
1051