Group - Dell PowerEdge M420 Reference Manual

Default Configuration
Configurations are enabled by default
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#no enable

group

Use the group command to configure the group number for a captive portal
configuration. If a group number is configured, the user entry (Local or
RADIUS) must be configured with the same name and the group to
authenticate to this captive portal instance. Use the "no" form of this
command to reset the group number to the default.
Syntax
group-number
group
no group
group-number — The number of the group to associate with this
•
configuration (Range: 1–10).
Default Configuration
The default group number is 1.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
1280
Captive Portal Commands