Ipv6 Mld Snooping Querier Election Participate; Ipv6 Mld Snooping Querier Query-Interval - Dell PowerEdge M420 Reference Manual

ipv6 mld snooping querier election participate

Use the ipv6 mld snooping querier election participate command to enable
the Snooping Querier to participate in the Querier Election process when it
discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier's source address
is higher than the Snooping Querier's address, it stops sending periodic
queries. If the Snooping Querier wins the election then it will continue
sending periodic queries. Use the "no" form of this command to disable
election participation on a VLAN.
Syntax
vlan-id
ipv6 mld snooping querier election participate
vlan-id
no ipv6 mld snooping querier election participate
vlan-id — A valid VLAN ID. (Range: 1 - 4093)
•
Default Configuration
Election participation is disabled by default.
Command Mode
VLAN Database mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-vlan)#ipv6 mld snooping querier
election participate 10

ipv6 mld snooping querier query-interval

Use the ipv6 mld snooping querier query-interval command to set the MLD
Querier Query Interval time. It is the amount of time in seconds that the
switch waits before sending another general query. Use the "no" form of this
command to reset the Query Interval to the default.
502
IPv6 MLD Snooping Querier Commands