Area Nssa (Router Ospf) - Dell PowerEdge M420 Reference Manual

Default Configuration
10 is the default configuration for
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example identifies a stub area of 10 and default cost of 100.
console(config)#router ospf
console(config-router)#area 10 default-cost 100

area nssa (Router OSPF)

Use the area nssa command in Router OSPF Configuration mode to
configure the specified area ID to function as an NSSA. If the area has not
been previously created, this command creates the area and then applies the
NSSA distinction. If the area already exists, the NSSA distinction is added or
modified. Use the no form of the command to remove the NSSA distinction
from the specified area ID.
Syntax
area-id
area nssa [no-redistribution] [default-information-originate [metric
metric-value
] [metric-type
role role] [translator-stab-intv interval]
area-id
no area
summary] [translator-role] [translator-stab-intv]
Parameter Description
Parameter
area-id
1070
OSPF Commands
metric-type-value
nssa [no-redistribution] [default-information-originate] [no-
Description
Identifies the OSPF stub area to configure. (Range: IP address
or decimal from
integer
.
]] [no-summary] [translator-
0–4294967295)