Area Virtual-Link - Dell PowerEdge M420 Reference Manual

Example
The following example prevents the Summary LSA from being advertised
into the area 3 NSSA.
console(config-router)#area 3 stub no-summary

area virtual-link

Use the area virtual-link command in Router OSPF Configuration mode to
create the OSPF virtual interface for the specified area-id and neighbor
router. To remove the link, use the no form of the command. Use the optional
parameters to configure authentication, dead-interval, hello-interval,
retransmit-interval and transmit-delay. If the area has not been previously
created, it is created by this command. If the area already exists, the virtual-
link information is added or modified.
Syntax
area-id
area virtual-link
hello-interval seconds
[
seconds dead-interval seconds
] [
key-id md5 key
digest-key
area-id
no area virtual-link
hello-interval
[ ] [
authentication-key
[[
Parameter Description
Parameter
area-id
router-id
authentication
message-digest
null
router-id
[
retransmit-interval seconds
] [
] [[authentication-key
]]
router-id
retransmit-interval
message-digest-key
] | [
Description
Identifies the OSPF stub area to configure. (Range: IP address
or decimal from 0-4294967295)
Valid IP address.
Specifies authentication type.
Specifies that message-digest authentication is used.
No authentication is used. Overrides password or message-
digest authentication if configured for the area.
authentication message-digest
[
authentication
[
transmit-delay
] [
]]
null
|
transmit-delay
] [
key
] | [message-
message-digest
[
dead-interval
] [ ]
OSPF Commands
]]
null
| ]]
1079