Area Virtual-Link Dead-Interval - Dell PowerEdge M420 Reference Manual

neighbor-id — Identifies the Router identifier of the neighbor.
•
• encrypt — Use MD5 Encryption for an OSPF Virtual Link.
key — Authentication key for the specified interface. (Range: 8 bytes or
•
less if the authentication type is simple and 16 bytes or less if the type is
encrypt.)
key-id — Authentication key identifier for the authentication type
•
encrypt. (Range: 0–255)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
Unauthenticated interfaces cannot be configured with an authentication key.
If no parameters are specified after the authentication keyword, then plain-
text password authentication is used.
Example
The following example configures the authentication type and key for the
area 10 OSPF virtual interface and neighbor ID.
console(config-router)#area 10 virtual-link
192.168.2.7 authentication
console(config-router)#area 10 virtual-link
192.168.2.7 authentication encrypt test123 1001010

area virtual-link dead-interval

Use the area virtual-link dead-interval command in Router OSPF
Configuration mode to configure the dead interval for the OSPF virtual
interface on the virtual interface identified by area-id and neighbor router.
Use the no form of the command to return the dead interval to the default
value.
1082
OSPF Commands