Dell PowerEdge M420 Reference Manual page 931

Syntax Description
Parameter
ip-address
mask
prefix-length
longer-prefixes
protocol
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the IPv4 address of the default gateway and
the default route associated with the gateway.
console#show ip route
Route Codes: R - RIP Derived, O - OSPF Derived, C -
Connected, S - Static
B - BGP Derived, IA - OSPF Inter Area
E1 - OSPF External Type 1, E2 - OSPF External Type 2
N1 - OSPF NSSA External Type 1, N2 - OSPF NSSA
External Type 2
Description
Specifies the network for which the route is to be displayed and
displays the best matching best-route for the address.
Subnet mask of the IP address.
Length of prefix, in bits. Must be preceded with a forward slash
(/). (Range: 0-32 bits.)
ip-address
Indicates that the
prefix, and the command displays the routes to the addresses
that match that prefix.
Specifies the protocol that installed the routes. (Range:
connected, ospf, rip static)
subnet-mask
and pair becomes the
IP Routing Commands
931