Switchport Mode - Dell PowerEdge M420 Reference Manual

Default Configuration
The default value for the
Otherwise, the value is 4093.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to configure the PVID for 1/0/8, when the
interface is in general mode.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#switchport general pvid 234

switchport mode

Use the switchport mode command in Interface Configuration mode to
configure the VLAN membership mode of a port. To reset the mode to the
appropriate default for the switch, use the no form of this command.
Syntax
switchport mode {access | trunk | general}
no switchport mode
Parameter Description
Parameter
access
vlan-id
parameter is 1 when the VLAN is enabled.
Description
An access port connects to a single end station belonging to a
single VLAN. An access port is configured with ingress filtering
enabled and will accept either an untagged frame or a packet
tagged with the access port VLAN. An access port transmits
only untagged packets.
VLAN Commands
743