Ipv6 Access-List - Dell PowerEdge M420 Reference Manual

Default Configuration
This command has no default configuration.
Command Mode
IPv6-Access-List Configuration mode
User Guidelines
Users are permitted to add rules, but if a packet does not match any user-
specified rules, the packet is dropped by the implicit "deny all" rule.
The 'no' form of this command is not supported, since the rules within an
IPv6 ACL cannot be deleted individually. Rather, the entire IPv6 ACL must
be deleted and re specified.
Example
The following example creates rules in an IPv6 ACL named "STOP_HTTP"
to discard any HTTP traffic from the 2001:DB8::/32 network, but allow all
other traffic from that network:
console(config)#ipv6 access-list STOP_HTTP
console(Config-ipv6-acl)#deny ipv6 2001:DB8::/32 any
eq http
console(Config-ipv6-acl)#permit ipv6 2001:DB8::/32
any
console(Config-ipv6-acl)#

ipv6 access-list

The ipv6 access-list command creates an IPv6 Access Control List (ACL)
consisting of classification fields defined for the IP header of an IPv6 frame.
name parameter is a case-sensitive alphanumeric string from 1 to 31
The
characters uniquely identifying the IPv6 access list.
If an IPv6 ACL with this name already exists, this command enters Ipv6-
Access-List config mode to update the existing IPv6 ACL.
Use the no form of the command to delete an IPv6 ACL from the system.
480
IPv6 Access List Commands