Maximum-Paths - Dell PowerEdge M420 Reference Manual

seconds — Sets the estimated number of seconds it takes to transmit a link
•
state update packet over this interface. (Range: 1–3600 seconds)
Default Configuration
1 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transit Delay for VLAN 15 at 20
seconds.
console(config-if-vlan15)#ip ospf transmit-delay 20

maximum-paths

Use the maximum-paths command in Router OSPF Configuration mode to
set the number of paths that OSPF can report for a given destination. Use the
no form of the command to reset the number to the default value.
Syntax
maximum-paths
no maximum-paths
integer — Number of paths that OSPF can report for a given destination.
•
(Range: 1–4.)
Default Configuration
integer
4 is the default value.
Command Mode
Router OSPF Configuration mode.
integer
OSPF Commands
1105