Ping Ipv6 - Dell PowerEdge M420 Reference Manual

Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables Ipv6 unicast datagram forwarding.
console(config)#ipv6 unicast-routing
console(config)#no ipv6 unicast-routing

ping ipv6

Use ping ipv6 command in Privileged EXEC mode to determine whether
another computer is on the network. To use the command, configure the
switch for network (in-band) connection. The source and target devices must
have the ping utility enabled and running on top of TCP/IP . The switch can
be pinged from any IP workstation with which the switch is connected
through the default VLAN (VLAN 1), as long as there is a physical path
between the switch and the workstation. The terminal interface sends three
pings to the target station.
Syntax
ip-address
ping ipv6 {
ipv6-address — Target IPv6 address to ping.
•
hostname — Hostname to ping (contact). (Range: 1–158 characters). The
•
command allows spaces in the host name when specified in double quotes.
For example,
size — Size of the datagram. (Range: 48–2048 bytes)
•
Default Configuration
This command has no default configuration.
hostname
| } [size
console(config)#ping ipv6 "host name"
size
]
IPv6 Routing Commands
983