Ip Ospf Network - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Example
The following example disables OSPF MTU mismatch detection on VLAN
interface 15.
console(config-if-vlan15)#ip ospf mtu-ignore

ip ospf network

Use the ip ospf network command to configure OSPF to treat an interface as
a point-to-point rather than broadcast interface. To return to the default
value, use the no form of this command.
Syntax
ip ospf network {
no ip ospf network
broadcast — Set the network type to broadcast.
point-to-point — Set the network type to point-to-point
Default Configuration
Interfaces operate in broadcast mode by default.
Command Mode
Interface Configuration (VLAN) mode.
Usage Guidelines
OSPF treats interfaces as broadcast interfaces by default. Loopback interfaces
have a special loopback network type, which cannot be changed. When there
are only two routers on the network, OSPF can operate more efficiently by
treating the network as a point-to-point network. For point-to-point
networks, OSPF does not elect a designated router or generate a network link
state advertisement (LSA). Both endpoints of the link must be configured to
operate in point-to-point mode.
Example
The following example shows the options for the ip ospf network command.
console(config-if-vlan1)#ip ospf network ?
1102
OSPF Commands
broadcast
point-to-point
|
}

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents