Dell PowerEdge M420 Reference Manual page 457

Parameter
Admin Mode
Admin Version
Source IP Address
Query Interval
Querier Timeout
When you specify a value for
Parameter
VLAN Admin Mode Indicates whether IGMP Snooping Querier is active on the
VLAN Operational
State
VLAN Operational
Max Response Time
Querier Election
Participate
Last Querier
Address
Last Querier Version Indicates the IGMP version of the most recent Querier from
Description
Indicates whether or not IGMP Snooping Querier is active on
the switch.
Indicates the version of IGMP that will be used while sending
out the queries.
Shows the IP address that is used in the IPv4 header when
sending out IGMP queries. It can be configured using the
appropriate command.
Shows the amount of time in seconds that a Snooping Querier
waits before sending out the periodic general query.
Displays the amount of time to wait in the Non-Querier
operational state before moving to a Querier state.
vlan_id
Description
VLAN.
Indicates whether IGMP Snooping Querier is in the Querier or
Non-Querier state. When the switch is in Querier state it sends
out periodic general queries. When in Non-Querier state it
waits for moving to Querier state and does not send out any
queries.
Indicates the time to wait before removing a Leave from a host
upon receiving a Leave request. This value is calculated
dynamically from the Queries received from the network. If the
Snooping Switch is in Querier state, then it is equal to the
configured value.
Indicates whether the IGMP Snooping Querier participates in
querier election if it discovers the presence of a querier in the
VLAN.
Indicates the IP address of the most recent Querier from which
a Query was received.
which a Query was received on this VLAN.
IGMP Snooping Querier Commands
, the following information appears.
457