Match Source-Address Mac - Dell PowerEdge M420 Reference Manual

Example
The following example displays adding a match condition based on the "ip"
protocol name keyword.
console(config-classmap)#match protocol ip

match source-address mac

Use the match source-address mac command in Class-Map Configuration
mode to add to the specified class definition a match condition based on the
source MAC address of the packet.
Syntax
match source-address mac
macaddr — Specifies any valid layer 2 MAC address formatted as six two-
•
digit hexadecimal numbers separated by colons.
macmask — Specifies a layer 2 MAC address bit mask formatted as six
•
two-digit hexadecimal numbers separated by colons. This bit mask does
not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds to the specified class definition a match
condition based on the source MAC address of the packet.
console(config-classmap)# match source-address mac
10:10:10:10:10:10 11:11:11:11:11:11
address macmask
QoS Commands
625