Port Aggregator Commands; Add Ethernet - Dell PowerEdge M420 Reference Manual

Port Aggregator Commands

This chapter explains the following commands:

add ethernet

duplex
minimum active uplinks
mtu disable
add ethernet
Use the add ethernet command to add member Ethernet ports to the
Aggregator Group. To remove member Ethernet ports from the Aggregator
Group/Zone, use the no form of this command.
Syntax
intf-list
add ethernet
intf-list
no add ethernet
intf-list — List of Ethernet interfaces. Separate nonconsecutive ports with
•
a comma and no spaces. Use a hyphen to designate a range of ports.
(Range: valid Ethernet interface list or range)
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
negotiation
port-aggregator group
show bridge address-table
speed
Port Aggregator Commands
29
565