Ipv6 Address Dhcp - Dell PowerEdge M420 Reference Manual

Configure a default gateway on vlan 10
console(config)#no ipv6 address autoconfig
console(config)#no ipv6 address 2003::6/64
console(config)#no ipv6 address 2001::/64 eui64
console(config)#no ipv6 address

ipv6 address dhcp

Use the ipv6 address dhcp command in Interface (VLAN) Configuration
mode to enable the DHCPv6 client on an IPv6 interface.
Syntax
ipv6 address dhcp
no ipv6 address dhcp
Parameter Description
This command does not require a parameter description.
Default Configuration
DHCPv6 is disabled by default on routing interfaces.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only applies to VLAN routing interfaces. When DHCPv6 is
enabled on a VLAN routing interface, the system automatically deletes all
manually configured IPv6 addresses on the interface.
471
IP Addressing Commands