Ipv6 Pimsm Dr-Priority - Dell PowerEdge M420 Reference Manual

priority —The priority of the candidate BSR. The BSR with the higher
•
priority is preferred. If the priority values are the same, the router with the
higher IP address is the BSR. (Range: 0–255).
Default Configuration
The router will not announce its candidacy by default.
The default hash mask length is 126 bits.
The default priority is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm bsr-candidate vlan 9 10 34

ipv6 pimsm dr-priority

Use the ipv6 pimsm dr-priority command to set the priority value for which a
router is elected as the designated router (DR). Use the "no" form of this
command to set the priority to the default.
Syntax
ipv6 pimsm dr-priority
no ipv6 pimsm dr-priority
priority —The election priority (Range: 0–2147483647).
•
Default Configuration
The default election priority is 1.
Command Mode
Interface Configuration (VLAN) mode
1052
IPv6 Multicast Commands
priority