Area Stub - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

User Guidelines
The LSDB type must be specified by either summarylink or nssaexternallink,
and the advertising of the area range can be allowed or suppressed.
Example
The following example creates an area range for the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 range 2020:1::1/64
summarylink

area stub

Use the area stub command in Router OSPFv3 Configuration mode to create
a stub area for the specified area ID. If the area has not been previously
created, this command creates the area and then applies the stub distinction.
A stub area is characterized by the fact that AS External LSAs are not
propagated into the area. Removing AS External LSAs and Summary LSAs
can significantly reduce the size of the link state database of routers within
the stub area.
Syntax
area-id
area
stub [no summary]
area-id
no area
area-id
— Valid OSPFv3 area identifier.
Parameter Description
Parameter
area-id
no-summary
Default Configuration
This command has no default configuration.
1152
OSPFv3 Commands
stub [no summary]
Description
Valid OSPFv3 area identifier.
Disable the import of Summary LSAs for the stub area
identified by area-id.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents