Dell PowerEdge M420 Reference Manual page 855

FILE LOCATION: C:\My Documents\ActiveProjects\2CSPC7000-SWUM400 Dell Zeiss CLI
User Guidelines
This command shows the DHCP status. Information displayed depends on
the mode.
The command output provides the following information for an interface
configured in client mode. Not all fields will be shown for an inactive client.
Term
Mode
State
Server DUID
T1 Time
T2 Time
Interface IAID
Leased Address
Preferred Lifetime
Valid Lifetime
Renew Time
Expiry Time
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 3 / 1 0 / 1 1 - F O R P R O O F O N LY
Guide\working\DHCPv6.fm
Description
Displays whether the specified interface is in Client, Relay, or
Server mode.
State of the DHCPv6 Client on this interface. The valid values
are:
INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW,
REBIND, RELEASE.
DHCPv6 Unique Identifier of the DHCPv6 Server on this
interface.
The T1 (in seconds) time as indicated by the DHCPv6 Server.
T1 value indicates the time interval after which the address is
requested for renewal.
The T2 (in seconds) time as indicated by the DHCPv6 Server.
T2 value indicates the time interval after which the Client
sends Rebind message to the Server in case there are no replies
to the Renew messages.
An identifier for an identity association chosen by this Client.
The IPv6 address leased by the DHCPv6 Server for this
interface.
The preferred life time (in seconds) of the IPv6 Address leased
by the DHCPv6 Server.
The valid life time (in seconds) of the IPv6 Address leased by
the DHCPv6 Server.
The time remaining (in seconds) to send a DHCPv6 Renew
request to DHCPv6 Server for the leased address.
The time (in seconds) when the DHCPv6 leased address
expires.
DHCPv6 Commands
855