Ip Address Dhcp (Interface Config) - Dell PowerEdge M420 Reference Manual

User Guidelines
This command has no user guidelines.
Example
console#
console#configure
console(config)#ip address-conflict-detect run

ip address dhcp (Interface Config)

Use the ip address dhcp command in Interface (VLAN) Configuration mode
to enable the DHCPv4 client on an interface.
Syntax
ip address dhcp
no ip address dhcp
Parameter Description
This command does not require a parameter description.
Default Configuration
DHCPv4 is disabled by default on routing interfaces.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only applies to routing interfaces. When DHCP is enabled on
a routing interface, the system automatically deletes all manually configured
IPv4 addresses on the interface.
• The command no ip address dhcp removes the interface's primary address
(Manual/DHCP) including the secondary addresses, if configured, and sets
the Interface method to None.
464
IP Addressing Commands