Example
The following example prevents Summary LSAs from being advertised into
the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 stub no-summary
area virtual-link
Use the area virtual-link command in Router OSPFv3 Configuration mode
to create the OSPF virtual interface for the specified area-id and neighbor
router. If the area has not been previously created, this command creates the
area and then applies the virtual-link parameters. To remove the link, use the
no form of the command. Use the optional parameters to configure dead-
interval, hello-interval, retransmit-interval and transmit-delay.
Syntax
area-id
area
virtual-link
seconds
interval
area-id
no area
[transmit-delay] [dead-interval]
Parameter
area-id
router-id
hello-interval
seconds
dead-interval
seconds
retransmit-interval
seconds
transmit-delay
seconds
1154
OSPFv3 Commands
router-id
] [transmit-delay
router-id id
virtual-link
Description
Valid OSPFv3 area identifier (or decimal value in the range of
0-4294967295).
Identifies the Router ID or valid IP address of the neighbor.
Number of seconds to wait before sending hello packets to the
OSPF virtual interface. (Range: 1–65535)
Number of seconds to wait before the OSPF virtual interface on
the virtual interface is assumed to be dead. (Range: 1–65535)
The number of seconds to wait between retransmitting LSAs if
no acknowledgement is received. (Range: 0–3600)
Number of seconds to increment the age of the LSA before
sending, based on the estimated time it takes to transmit from
the interface. (Range: 0–3600)
seconds
[hello-interval
seconds
] [dead-interval
[hello-interval] [retransmit-interval]
] [retransmit-
seconds
]