Dos-Control Sipdip - Dell PowerEdge M420 Reference Manual

Dell powerconnect m6220/m6348/m8024/m8024-k cli reference guide
Hide thumbs Also See for PowerEdge M420:
Table of Contents

Advertisement

Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates L4 Port Denial of Service protection.
console(config)#dos-control l4port

dos-control sipdip

Use the dos-control sipdip command in Global Configuration mode to
enable Source IP Address = Destination IP Address (SIP=DIP) Denial of
Service protection. If the mode is enabled, Denial of Service prevention is
active for this type of attack. If packets ingress with SIP=DIP , the packets is
dropped if the mode is enabled.
Syntax
dos-control sipdip
no dos-control sipdip
Default Configuration
Denial of Service is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example activates SIP=DIP Denial of Service protection.
console(config)#dos-control sipdip
1365
Denial of Service Commands

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents