Ipv6 Ospf Dead-Interval; Ipv6 Ospf Hello-Interval - Dell PowerEdge M420 Reference Manual

ipv6 ospf dead-interval

Use the ipv6 ospf dead-interval command in Interface Configuration mode
to set the OSPF dead interval for the specified interface.
Syntax
ipv6 ospf dead-interval
no ipv6 ospf dead-interval
seconds — A valid positive integer, which represents the length of time in
•
seconds that a router's Hello packets have not been seen before its
neighbor routers declare that the router is down. The value for the length
of time must be the same for all routers attached to a common network.
This value should be some multiple of the Hello Interval (i.e. 4).
(Range: 1-65535)
Default Configuration
40 seconds is the default value of
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF dead interval at 100 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf dead-interval 100

ipv6 ospf hello-interval

Use the ipv6 ospf hello-interval command in Interface Configuration mode
to set the OSPF hello interval for the specified interface.
seconds
seconds
.
OSPFv3 Commands
1167