Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
AutoCost Ref BW The configured autocost reference bandwidth. This value is used
Number of Active
A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
Shows whether OSPF is administratively enabled or disabled.
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
Shows the number of seconds that, after entering
OverflowState, as defined by RFC 1765, a router will attempt to
to determine the OSPF metric on its interfaces. The reference
bandwidth is divided by the interface speed to compute the
When enabled, OSPF interfaces are passive by default.
Shows the maximum number of paths that OSPF can report for
a given destination.
Default metric for redistributed routes.
When enabled, OSPF originates a type 5 LSA advertising a
When this option is configured, OSPF only originates a default
route when the router has learned a default route from another
Shows the metric for the advertised default routes. If the metric
is not configured, this field is not configured.
Shows whether the metric for the default route is advertised as
External Type 1 or External Type 2.
The number of OSPF areas to which the router is attached on
interfaces that are up.