Voice Vlan Data Priority; Show Voice Vlan - Dell PowerEdge M420 Reference Manual

console(config-if-Gi1/0/1)#voice vlan untagged

voice vlan data priority

This command is to either trust or not trust (untrust) the data traffic arriving
on the voice VLAN port.
Syntax
voice vlan data priority { trust | untrust }
• trust Trust the dot1p priority or DSCP values contained in packets
—
arriving on the voice vlan port.
• untrust
—
packets arriving on the voice vlan port.
Command Mode
Interface Configuration
Default Value
trust
Example
console(config-if-1/0/1)#voice vlan data priority untrust
console(config-if-1/0/1)#voice vlan data priority trust

show voice vlan

show voice vlan [interface {gigabitethernet
tengigabitethernet
Syntax
When the interface parameter is not specified, only the global mode of the
voice VLAN is displayed.
When the interface parameter is specified, the following is displayed:
760
Voice VLAN Commands
Do not trust the dot1p priority or DSCP values contained in
unit/slot/port
unit/slot/port
| all}]
|