Ipv6 Ospf Transmit-Delay; Ipv6 Router Ospf - Dell PowerEdge M420 Reference Manual

console(config-if-vlan15)#ipv6 ospf retransmit-
interval 100

ipv6 ospf transmit-delay

Use the ipv6 ospf transmit-delay command in Interface Configuration mode
to set the OSPF Transmit Delay for the specified interface.
Syntax
ipv6 ospf transmit-delay
no ipv6 ospf transmit-delay
seconds — OSPF transmit delay for the specified interface. In addition, it
•
sets the estimated number of seconds it takes to transmit a link state
update packet over this interface. (Range: 1 to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transmit Delay at 100 seconds for
VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf transmit-delay
100

ipv6 router ospf

Use the ipv6 router ospf command in Global Configuration mode to enter
Router OSPFv3 Configuration mode.
1172
OSPFv3 Commands
seconds