Ipv6 Hop-Limit - Dell PowerEdge M420 Reference Manual

Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables IPv6 routing, which has not been configured
with an explicit IPv6 address.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 enable

ipv6 hop-limit

Use the ipv6 hop-limit command to configure the hop limit used in IPv6
PDUs originated by the router. Use the no form of the command to return
the hop limit to the default setting.
Syntax
ipv6 hop-limit
no ipv6 hop-limit
Parameter Description
Parameter
count
Default Configuration
The default count is 64 hops.
964
IPv6 Routing Commands
count
Description
The number of hops before the PDU expires (Range 0-255).