Gvrp Enable (Interface) - Dell PowerEdge M420 Reference Manual

Default Configuration
GVRP is globally disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables GVRP on the device.
console(config)#gvrp enable

gvrp enable (interface)

Use the gvrp enable command in Interface Configuration mode to enable
GVRP on an interface. To disable GVRP on an interface, use the no form of
this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces by default.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
An Access port cannot join dynamically to a VLAN because it is always a
member of only one VLAN.
430
GVRP Commands