Ip Igmp Last-Member-Query-Interval - Dell PowerEdge M420 Reference Manual

Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets 10 as the number of VLAN 2 Group-Specific
Queries.
console#configure
console(config)#interface vlan 2
console(config-if-vlan2)#ip igmp last-member-query-
count 10
console(config-if-vlan2)#no ip igmp last-member-
query-count

ip igmp last-member-query-interval

Use the ip igmp last-member-query-interval command in Interface
Configuration mode to configure the Maximum Response Time inserted in
Group-Specific Queries which are sent in response to Leave Group messages.
Syntax
ip igmp last-member-query-interval
no ip igmp last-member-query-interval
tenthsofseconds — Maximum Response Time in tenths of a second
•
(Range: 0-255)
Default Configuration
The default Maximum Response Time value is ten (in tenths of a second).
876
IGMP Commands
tenthsofseconds